Attention should be paid to the installation of spiral bevel gears

Spiral Bevel Gears have always been used well in our daily lives, and it can be said that most mechanical equipment is used. If we want to maintain its performance and reduce the failure rate, then we need to pay more attention during installation.
Unmanned Helicopter

Generally speaking, when installing a Spiral Bevel Gear, we need to adjust the centerline of the two shafts to the same plane before we can start assembling the following components. Secondly, for the coloring inspection of the contact surface of the Bevel Gear, we should note that the shaft should not be moved in series throughout the entire rotation process, and ensure that the contact surface is close to the small end of the gear even when there is no load. Another point is the requirement for the contact spot on the meshing tooth surface. Generally speaking, our requirement is to be above 70%. At the same time, we can also adjust the gear meshing clearance by adjusting the thickness of the gasket. It should be noted that the clearance of the spiral bevel gear cannot be too large or too small, otherwise it will have a significant impact on our use